Or
Reference: 2170089
| Manufacturing origin | Swiss |
| Voltage | 380 / 50 / 3 |
| Netweight | 4900 lbs |
| Custom position | 8460.2920 |
| Nominal distance between centre | 600 mm |
| Max. distance between centres, headstock and tailstock | |
| projecting | 750 mm |
| Height of centres, standard | 125 mm |
| Height of centres by means of raising blocks for work | |
| head-and tailstock | 175 => 250 mm |
| Max. swing diameter with 125 mm height of centres | 250 mm |
| Max. swing diameter with raising blocks | 350 => 500 mm |
| Table swivels each side | 10� |
| Max. lenght for surface grinding (width=200 mm) | 900 mm |
| Table speed infinitely viable by hydraulic drive, approx. .. | 6 m/min |
| Dwell of table reversal | 0 - 5 sec. |
| Grinding wheel for cylinrical grinding | |
| (diameter x width x hole) | 350/400x50x127mm |
| Grinding wheel for surface grinding diameter x width x hole | 250 x 13 x 76 |
| Speeds of grinding wheel spindle | 1500/1700/2200/3600 |
| Grinding wheel head swivels | 270� |
| with indexed stop each | 90� |
| Vertical movement of grinding wheel head, height of | |
| centres | -350 mm |
| Cross movement of grinding wheel head | 285 mm |
| Rapid advance and withdrawal of wheelhead | 40 mm |
| Intermittent infeed per reversal of table | 0,001-0,03 mm/dia |
| Infeed for plunge grinding | 0-0,9 mm/dia |
| Micro-corrector of infeed, 1 division of dial | 0,001 mm/dia |
| Swivel of work headstock | 360� |
| work speeds infinetely viable, normal/special | 20-400/10-400 |
| Internal taper of headstock/tailstock | 5/3 Morse |
| Grinding wheel motor, approx. | 4 HP |
| errors and omissions excepted data given without obligation | |
